front driveshaft help - FSB Forums
 
LinkBack Thread Tools Display Modes
post #1 of 3 (permalink) Old 12-09-2012, 09:23 PM Thread Starter
Registered User
 
Join Date: Feb 2010
Location: zephyrhills fla
Posts: 27
Bronco Info: 79 302 c-6 513 spooled rear 14 inch 4 link lift front springs rear 22gal water tank to keep clean
front driveshaft help

here is my problem i have a 1989 bronco with a hp 44 and i think 14 inches of lift there is 19inches between the top of axle to bottom of frame it is 4linked .It had a Borg Warner 1345 in when i bought the truck drive shaft was fine .i put a 205 in it and the drive shaft is to steep i clocked it down 3 inchs and have a double-cardan shaft that i shaved down for more flex in it.i have 750$ in it now and im putting it in the truck. The easyest thing would put the 1345 back in it not going to happem i dont want to spend a ton of money on high angle ujoint im thinking of lowering the motor 5 inches and building a new kframe any help would be nice
charley white is offline  
Sponsored Links
Advertisement
 
post #2 of 3 (permalink) Old 12-11-2012, 06:23 PM
Registered User
 
Join Date: Mar 2012
Location: paragould, ar
Posts: 11
Bronco Info: 92 solid axle, big block, one ton axles, 5 speed sitting on 14.5/2- michelin xl's
if you have the cash you may want to go with a drop transfer case
fordman1920032003 is offline  
post #3 of 3 (permalink) Old 12-11-2012, 10:04 PM Thread Starter
Registered User
 
Join Date: Feb 2010
Location: zephyrhills fla
Posts: 27
Bronco Info: 79 302 c-6 513 spooled rear 14 inch 4 link lift front springs rear 22gal water tank to keep clean
thanks fordman1920032003 i was thinking that but the bronco wheel base is so short i was worried about the back drive shaft so i cut the k frame out today . then i put both drive shats in and lowered the engine down till both shafts were good. i had to lower it 3.5 inchs. so now i will rebuild the kframe and trans crossmember .
charley white is offline  
Reply

  FSB Forums > Bronco Discussions > Noobie Bronco Tech Questions. Flame free zone!

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the FSB Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself. DO NOT USE Gmail.com accounts. If you only have a Gmail.com email please contact the administrator here

Email Address:
OR

Log-in









Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode



Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome