ok, Im real close to starting up the new lightening motor, but the harness and computer need the the TAD,TAB,EGR sols hooked up.
Can I just clip the fittings, close the loops on the wire and call it good? Meaning, take the respeective red wires and respoective brown or wh/pink wires, and wire them together? Will that send the signal to the computer that I need?
No need to mount sensors to the motor if I am not using them, so hopefully I can just wire them together and call it good.
You do not want to just short the wires together, the solenoids act as the loads, using the current. No load and the current goes straight to ground shorting out the system and causing lots of probs. I don't know what would work, just leaving them disconnected would probably throw codes. For the EGR, there are adapter plugs that trick the pcm into thinking there is one attached.
Or do it yourself. 75ohm resistors for the EGR, TAB and TAD solenoids. The EVP is also important. Get an eliminator for that or make one yourself, too. I'm not sure I can post the picture for the EVP resistor values as RJM took it off their site.
they wont be fixed properly. This thing is going into a 61 scout after this season, so all smog has been pulled for easier install when I went to the GT40 intakes. I no longer have the smog pump or diverters. As a result, i dont need the solenoids. I would rather not have to worry about mounting them, and just bypass them so I can start this thing and run it for three months, before it gets mustang FI.
Heres the resistor values and a diagram for deleting the EVP.
I've done this to a few trucks and it works great. The engine runs like it should and it doesn't throw codes(except for insufficient EGR flow). So the above along with resistors to replace the vacuum solenoids and you should be set.
Edit: BTW, putting the resistors in just gives the computer a constant "closed" signal. So it thinks everything is closed and off. This is important for it to adjust the fuel and spark curve correctly. If you did nothing and just unplugged it all, the computer will still adjust as if its there.
Plug did you ever get the evp and TAB/TAD taken care of? i am considering this also and could use some help.
For Sale - 94 XLT 357/E4OD Trans-go stage II
6" Stage II ProComp,35" BFG/AT 4.88 f (aussie) / r (open) / Custom Sliders, Custom bumper Warn HS9500, Edelbrock truck upper/lower,JBA headers,Custom Y pipe hi flow cat & Full 3"