Dangling_Dave
08-03-2004, 04:20 PM
Hi, I am posting all the parts I took off during the SAS in June. I would rather sell this as a complete set as I have to get rid of it ASAP.
Ok I know that this is not the for sale section but I would rather sell this in Colorado. That being said I will deliver this to anywhere in Colorado that is 1/2 tank of gas (about 150 miles) from Arvada. Or else you can come and pick it up at my storage unit at I-70 and Wadsworth.
For Sale, front and rear axles out of 1996 Bronco $500.00.
Front Axle: Dana-44 TTB setup, 4.10 gear ratio, Detroit TrueTrac LSD, rebuilt front axle assemblies with Spicer 5-760 U-Joints. Axle beams included and have fresh pivot bushings. Superlift drop TTB bracket, good radius arms and bushings. Rancho 4" TTB Lift Brackets. Ball Joints in good condition, brakes in good condition (disks a little rusty due to rain), wheel bearings repacked in April. I might have some spare u-joints to throw in if I can find them.
Rear Axle: Ford 8.8" rear axle assembly, 4.10 gear ratio, Detroit TrueTrac LSD, good brakes, shock mounts relocated to level with axle tube. Axle tube has slight crack at passenger side spring pad which is normal for this axle and can be welded. Good axle shafts. Superlift 3" lift blocks and U-Bolts.
Misc. other stuff, 1 good rotor disk, 2 good spare brake drums, shocks and misc. other hardware.
Thanks in Advance
dc
Ok I know that this is not the for sale section but I would rather sell this in Colorado. That being said I will deliver this to anywhere in Colorado that is 1/2 tank of gas (about 150 miles) from Arvada. Or else you can come and pick it up at my storage unit at I-70 and Wadsworth.
For Sale, front and rear axles out of 1996 Bronco $500.00.
Front Axle: Dana-44 TTB setup, 4.10 gear ratio, Detroit TrueTrac LSD, rebuilt front axle assemblies with Spicer 5-760 U-Joints. Axle beams included and have fresh pivot bushings. Superlift drop TTB bracket, good radius arms and bushings. Rancho 4" TTB Lift Brackets. Ball Joints in good condition, brakes in good condition (disks a little rusty due to rain), wheel bearings repacked in April. I might have some spare u-joints to throw in if I can find them.
Rear Axle: Ford 8.8" rear axle assembly, 4.10 gear ratio, Detroit TrueTrac LSD, good brakes, shock mounts relocated to level with axle tube. Axle tube has slight crack at passenger side spring pad which is normal for this axle and can be welded. Good axle shafts. Superlift 3" lift blocks and U-Bolts.
Misc. other stuff, 1 good rotor disk, 2 good spare brake drums, shocks and misc. other hardware.
Thanks in Advance
dc