rem_243
02-19-2005, 10:34 PM
I know this question has been asked before, but I was looking for opinions on my shackles. How do these angles look? I am going to drill holes farther up in the rear hangers for the shackles, so I was just making sure these angles are good before I drill the holes. Thanks
http://www.supermotors.org/getfile/178640/fullsize/DSCF0059.JPG
http://www.supermotors.org/getfile/178646/fullsize/DSCF0062.JPG
MikE2
02-19-2005, 10:56 PM
That should be fine with the stock flat springs because squatting and dropping will pull the shackle loser to 90*
If ther were big arched springs you would want it closer to straingt up
rem_243
02-19-2005, 11:23 PM
Well I plan on putting on arched springs, so I will post back when I have those installed. Thanks Mike.
MikE2
02-19-2005, 11:38 PM
The arched springs will probably put it in a good position. They are usually a little shorter to correct that
TTBlows
02-21-2005, 12:35 AM
Those hangers look like they're still riveted on......is this an F250+ already?
Angle's a little shallow but ok IMO.
rem_243
02-21-2005, 01:24 PM
Those hangers look like they're still riveted on......is this an F250+ already?
Angle's a little shallow but ok IMO.
Yeah, It's on an F250.
TTBlows
02-22-2005, 12:27 PM
Did you fab those shackles, or is that O$R$U's kit?
rem_243
02-22-2005, 03:01 PM
Did you fab those shackles, or is that O$R$U's kit?
no it's not O$R$U's kit, i didn't make the shackles