http://www.superford.org/articles/022003/panel_repair_header.jpg

i found this on SuperFord looks helpfull :shrug

http://www.superford.org/garage/articles/022003/panel_repair_1.php

Looks pretty interesting Cory!

Mine is too far gone for that. :mad:

:lolup :lolup :lolup :lolup :lolup :lolup

But this has got me thinking...

I could buy these fiberglass quarter panels for $500:
http://www.autofab.com/bronco3_10-3-98_5_55_PM.jpg

Then cut out the wheel well and re-fiberglass the 80-86 wheel arch :thumbup

I still think getting a rust free tub from the desert states would be better

That opening is already bigger then usual. At 500 bucks I would leave it like it is.

Fireguy are you saying you would buy these glass panels, then cut the wheel well section out then fiberglass it to yours??? It that is correct, why? Do as 81bronk36 said. Buy them and install them on yours. Don't cut them. That's alot of money just for some wheel wells when I am pretty sure you can the those weld in ones from LMC, JC Whittney, etc, etc..

:stupid

Me and my cousin chopped the wheel wells out of an 87 long box F-150 and welded them into the 81 bronco tub .... made for an interesting look. unfortunately they are about the only good sections left on the rear of the tub :(

Hey fireguy. Where can you get those glass pannels? I want em.

those are autofab panels....they also have the 92-96 fiberglass front clip and fiberglass tailgate also www.autofab.com i believe is the site

Ok next Q. DO you think there are any companies that make pannels for an 85 body style?

Ok next Q. DO you think there are any companies that make pannels for an 85 body style?

LMC Truck, CertiFit, Bronco Graveyard.....