Anyone got one they's like to part with?

talk to burnedb.
i have got some parts from him before, he's a good guy to deal with.

Thanks, I sent him a PM.

we got a few if you don't find anything then

Tried to PM ya, but your box was full, so I sent ya an email.

box is cleaned up now but got your email will talk with the bf and let you know what we got

Ive got one out of an 03 excursion, complete but it is bent on the left side, will sell or trade reasonably if you are interested.

Thanks, but I need the older style for my plans.

Still looking. Found some for $1000, but still looking.

would a 90 F350 axle work? its a d60 full width.

No, for radius arms I need 78/79.

btt

dont have one but i thought this might help ya out

http://www.projectbronco.com/Technical_Articles/RCdana_60_conversion.htm

dont have one but i thought this might help ya out


I see nothing? :twak

Boy Gub this is ironic, I tried to sell my 78 D60 a few months ago but got nothing. Now i am committed to the SAS and got the rad arms for it from you. If you asked this 4 months eariler you would have had it.

Yeah, got those shipped out yesterday. I had to make a box for them. I hope they get there ok.

not sure of your plans gub but can you use 83.5 prior? i beleive they are exactly the same. after 83.5 is when the changed the spring width. just a thought

not sure of your plans gub but can you use 83.5 prior? i beleive they are exactly the same. after 83.5 is when the changed the spring width. just a thought

They changed it in 1980 also. I need 78/79 for my project. Thanks!

i have a front and rear im looking to get rid of

I know of one here in east TN if it is still there. Would you trade some tool turning time on an upcomming 79 rear disk conversion with the F350 MC and booster upgrade? I'm located up Stoney creek in Etown.

I've got a whole bronco for sale with a 78 dana 60 allready installed using the coilsprings and the stock radius arms.

There are three ford dana 60 fronts on ebay now.