Looking for rear driveshaft for my 85 Bronco. One from an 80 to late eighties will probably work.

Thanks,
Danny

Still looking

no junkyards around your area?

no junkyards around your area?

Actually you'll need one from an '85-'86 only. They use a different flange than other years. I trashed the driveshaft in my '85 a while back and had hell finding another one. Good luck

I have one out of my 85 it is made for a 6in lift email me if interested
F351wc6@aol.com

no junkyards around your area?

I've been at work too much lately, and consequently the JY's are only open when I am at work.


Actually you'll need one from an '85-'86 only. They use a different flange than other years. I trashed the driveshaft in my '85 a while back and had hell finding another one. Good luck

I did not know that. What the heck is different? I just assumed all 208's used the same size U-joint.


I have one out of my 85 it is made for a 6in lift email me if interested
F351wc6@aol.com

I got your pm. That is more than I was hoping to spend plus I am going to have to lengthen it anyway because I moved my rear axle back 7".

Anyone else?

Thanks,
Danny

'85 and '86 use an odd ball yoke on the rear output shaft of the transfer case.

I'm still looking. Still fawking working 6 days a week and can't get to the JY.

Thanks,
Danny

I'm still looking. Still fawking working 6 days a week and can't get to the JY.

Thanks,
Danny

Same situation. Still looking.

DK

Still looking.