plug ugly
01-08-2006, 05:08 PM
I need a yoke for a 1350 ujoint. Dont care what its from, or if its damaged. I need one for alittle project.
What do you have?
What do you have?
|
View Full Version : wanted - 1350 yoke plug ugly 01-08-2006, 05:08 PM I need a yoke for a 1350 ujoint. Dont care what its from, or if its damaged. I need one for alittle project. What do you have? BuckingBronco93 01-09-2006, 02:41 AM This maybe a dumb respond, but I have a extra driveshaft out of a '93 Bronco XLT with the E40D tranny, and 5.0L V8. The drive shaft has no u-joints. I have both ends where they meat up the ujoints to the driveshaft. plug ugly 01-09-2006, 01:40 PM not what i need, but thanks plug ugly 01-13-2006, 12:34 PM TOP 96broncoman 01-13-2006, 04:27 PM plug, i have 97 f350 drive shafts that came with my sterling.....would those work, the yokes i mean??? plug ugly 01-16-2006, 01:14 AM did you swap out the yoke on the 60 or sterling? Stock is usually 1330 or 1310 IIRC, so its doubtful. Im not looking for the slip yoke, actually (shouldhave been more specific) but the axle or tcase yokes. desertrat_666 01-18-2006, 01:17 PM u still need 1350 yoke? Have new one for np 205. plug ugly 01-20-2006, 10:56 PM oooohhhh, that might be perfect. I "think" I found one, but will let you know this weekend. Spectre 01-21-2006, 06:04 PM My neighbor needs a front yoke Xfer case side out of an F350.. (basically the yoke that will alow him to take a rear bronco driveshaft and put it on the front) <my yoke came out of an old F350 that had a Dana 60 in it.. Don't know what the yoke # is or xfer case # is. plug ugly 01-22-2006, 05:37 PM what? desertrat_666 01-25-2006, 01:02 AM pm sent Spectre 01-25-2006, 04:34 PM I need the front Xfer case Yoke from an F350.. What is the number for it? plug ugly 01-25-2006, 10:02 PM wht the hell are you asking n a thread i started about wanting my own yoke? Start your own thread. |