Link (http://cgi.ebay.com/ebaymotors/1981-Ford-Bronco-Trailer-Special_W0QQitemZ4638906459QQcategoryZ6222QQrdZ1QQ cmdZViewItem)

Would make a great project or parts vehicle, clean fenders and floor boards, only has rust on the tail gate.

That makes me a saaaaad panda

That makes me a saaaaad panda

Believe me, I don't want to do it.

But...I figure once I'm back on my feet again I'll get another one. This is the second time I've had to do this, sold my 83' when I was down and out a few years ago.

Well good luck on selling it. I hope you get a good offer. You know Broncos are a bad investment. I have a 93 with hi-pinion Dana 60's/37" IROK's and 488 gears. I dont think I could get much for the thing if I had to sell it, that is with all the body damage I have.

Well good luck on selling it. I hope you get a good offer. You know Broncos are a bad investment. I have a 93 with hi-pinion Dana 60's/37" IROK's and 488 gears. I dont think I could get much for the thing if I had to sell it, that is with all the body damage I have.

Yeah, the body is really the only thing worth much on the Bronco, since it doesn't run. But its got a good C6, NP208, and 9", so its also a good parts Bronco.

The c6 alone is worth $500.00 so its like your getting a 9" axle, body, etc. for free. I wish I had the money too

Hmm I might have to come take a look at this. I need every body panel for my baby or I could just put my 351 in that body... hmmm

Hmm I might have to come take a look at this. I need every body panel for my baby or I could just put my 351 in that body... hmmm

Yup, all you'd have to do is drop that motor in and you'd be set, plus you'd have tons of spares!

PM me Doug, lets work out a time for you to come check it out. You're not going to find a Bronco this clean here in SLC, it'll be worth it, believe me.

There is about a day left on the auction, I'd really like to see it go to a member of FSB.com

Well my wife would KILL me if I bought the whole thing!! I was wondering about the carb and intake? Do you still have them? I would REALLY like that.

Well my wife would KILL me if I bought the whole thing!! I was wondering about the carb and intake? Do you still have them? I would REALLY like that.

Yup, sure do! $150 bucks for the set, plus they're small enough that you can hide them from the wife!

So did it sell... and if so how much? Im looking to sell my 9in rear and 351w motor and c6 tranny.. I will be posting them as soon as I get 20 post under my belt..