Anyone have a good picture of your edelbrock carb linkage on a 351m? I made my own extension, following the picture of it from jegs, but it's just not working like I thought it would. Is the extension supposed to be rigidly mounted to the lever, or should it stay just loose enough to pivot with the assembly?
Thanks.

Will this work? -

http://i83.photobucket.com/albums/j281/diamondback-motorsports/Edelbrock-linkage.jpg

I can get other angles, if you need it

here is the only picture i could find of mine, but i have a cable from the pedal to the carb. I also had to make the end up the pedal rod longer to level out the cable more because of the 2" carb spacer. I alos use 2 springs one strong one on front and a weaker one on back to balance out the pedal movement over really bumpy terrrain.
http://www.imagestation.com/picture/sraid220/pe1511bbf9f333644714ee946ca4da1ca/ebc7e5d2.jpg

Thanks guys. It looks like you both have some large contraption bolted onto the linkage. What is that, the missing link, perhaps? My carb just has a flat plate sticking out the side.:scratchhe

It's just a throttle linkage adapter. IIRC, mine cost me $14 at the parts store

alrighty then, I'll go check it out. Thanks:thumbup

check out this...
linkage adapters.
http://www.edelbrock.com/automotive/index.html

cool, thanks Red.:beer