hi-trax
02-27-2007, 10:06 PM
Anyone interested in trading an ATV for "Old Glory"?
I have an 83 Ford Bronco that has been "slightly" modified.
It has a 351W, with a 2150 motorcraft carb (best off-roading carb made ;)) c6 with a low stall torque converter and low end RV cam in the engine, 3" exhaust, 9" rearend, Dana 44 solid axle frontend. Lockrights front and rear. 4.11s.
I fabricated the solid axle front suspension with 3" Johny Joints and high clearance, extended radius arms and it flexes extremely well. It ended up being lifted about 5 inches. It currently has 33's but was designed for 35-37s.
I lived down in Moab for a while and it took me all over the place and always brought me back home.
The body is in very rough shape due to a couple of bad decisions in the 'Old Pickle' and 'Helldorado' but as a wise man once said, "She may not look like much kid, but she gots it where it counts". My next project was going to be removing the body anyways so I didn't worry about it too much. It also has a cracked Y pipe on the exhaust that needs to be replaced.
If you are looking to get into rockcrawling, this is a cheap way to get a very capable and reliable rig.
I am open to discussing any types of ATV trades, i.e. motorcycles, project bikes, odysseys, 3wheelers, partial trades, bikes that don't run, etc...
Let me know if anyone is interested.
$1500 or offer?
See at: http://www.ksl.com/?nid=218&ad=936606&cat=145&lpid=
I have an 83 Ford Bronco that has been "slightly" modified.
It has a 351W, with a 2150 motorcraft carb (best off-roading carb made ;)) c6 with a low stall torque converter and low end RV cam in the engine, 3" exhaust, 9" rearend, Dana 44 solid axle frontend. Lockrights front and rear. 4.11s.
I fabricated the solid axle front suspension with 3" Johny Joints and high clearance, extended radius arms and it flexes extremely well. It ended up being lifted about 5 inches. It currently has 33's but was designed for 35-37s.
I lived down in Moab for a while and it took me all over the place and always brought me back home.
The body is in very rough shape due to a couple of bad decisions in the 'Old Pickle' and 'Helldorado' but as a wise man once said, "She may not look like much kid, but she gots it where it counts". My next project was going to be removing the body anyways so I didn't worry about it too much. It also has a cracked Y pipe on the exhaust that needs to be replaced.
If you are looking to get into rockcrawling, this is a cheap way to get a very capable and reliable rig.
I am open to discussing any types of ATV trades, i.e. motorcycles, project bikes, odysseys, 3wheelers, partial trades, bikes that don't run, etc...
Let me know if anyone is interested.
$1500 or offer?
See at: http://www.ksl.com/?nid=218&ad=936606&cat=145&lpid=