Bronco Forum - Full Size Ford Bronco Forum banner

Fiberglass body parts

5K views 14 replies 9 participants last post by  bronco_buster 
#1 ·
I am looking for some fiberglass OEM style rear quaters, I have seen glasswerx and they 80 style just won't do

if you have a clean 78-79 I can use for molds,and you are near we can work something out

Happy Thanksgiving!
 
#7 ·
You're welcome to swing by here. Got the driver's side that I welded on....got the passenger side panel still sitting in a corner.....have the Autofab hood 80% installed.
We can certainly weld on repair panels at my place. If you want, shoot me a private message (PM), and I'll give you the address.
 
#13 ·
http://www.usbody.com/

How about a fiberglass tilt nose?? Put some pins in there, and simply remove them and lift off the whole nose when you want to do anything on the motor..
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top