Bronco Forum - Full Size Ford Bronco Forum banner

Harmonic balancer repair sleeve installation

9K views 4 replies 3 participants last post by  Sixlitre 
#1 ·
See less See more
2
#2 ·
Seal

Hi Sixlitre,

thanks a lot for your detailed description of how to improve the original balancer. I never heard about this repair sleeve before.

Before I start disassembling my Sweety I'd like to know how to put the crank seal into the TC Cover. Did you use Loctite or a non-hardening sealant? Or did you put it in as it was?

Sorry for my ignorance!

Thanks again
 
#5 ·
I can't remember if I slapped on any sealant around the seal or not ?

I may have, as I do remember there was some around the old one, but I never used to use it on any of the previous Mopar units I've done, like Bigric said.

As for how I did it, I put a huge rubber mallet over the seal and pounded it with a ballpeen hammer and it worked fine seating it in.

Good luck

Sixlitre
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top