Bronco Forum - Full Size Ford Bronco Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-9 of 9 Results
  1. 1980-'96 Bronco Tech
    I am currently looking for a first car and I am in love with the Broncos. I found a couple Eddie Bauers that caught my eye. The first one is an '85 that has obviously been sitting. It's a 5.0 EFI and the paint and interior look good. It does not have a title but I can get a bonded title. That...
  2. 1986 ford bronco Eddie bauer 5.0

    Automatic od, manual hubs, power everything (used to be) factory ac (used to have), blue n tan on tan interior. 33 m3 bfgoodwrench, powers top rotors and hawk pads, borla n 3 inch exhaust...
  3. Noobie Bronco Tech Questions. Flame free zone!
    Curious if anyone has any tips or tricks. I have original low back bucket seats in my 1986 Bronco and bought a set of 1994 Extended Cab F150 Seats to swap into the truck. I notice originally the new seats did not bolt to the floors on the passenger side. The low backs have a spring-loaded...
  4. Noobie Bronco Tech Questions. Flame free zone!
    I got a 1986 bronco 5.0 auto, got the truck drove it 3 hours home fine. Drove around here and there and then it didnt want to start replaced pickup pump in the tank and it started up fine and worked for a while. The. It couldnt hold idle and rpms were up and down a bit would stall when stopping...
  5. Noobie Bronco Tech Questions. Flame free zone!
    Question for all you Bronco Gurus. Looking for mounting brackets for '80-'86 "styleside" rear bumper. Needless to say, they are HARD to find. Are there any other years that will work? Know of any for sale? Thanks! Dwayne
  6. Noobie Bronco Tech Questions. Flame free zone!
    Hello, Tuesday I am going to look at a 1986 Ford Bronco at a pick n pull. I have always wanted a Bronco, and at $1799 (OBO), I feel like this could be a good get. There isn't that much info on the site other than it runs ("fires right up") and that it looks to be complete with a salvage title...
  7. 1980-'96 Bronco Tech
    On this never ending mission to get this baby running right I now have a code 25. Did some searching on here, found some posts saying if you have 2.4-2.6 volts at the connector you're golden. The Haynes Manuel says it needs to be at least 5 volts with key on engine off. :eek: I've got wiring...
  8. 1980-'96 Bronco Tech
    Hello all, I have a 1986 Ford Bronco with the 5.0L EFI and a 4 speed manual. My efi fueling is on a base curve as someone before me removed all the sensors for electronic control. The fuel pumps are on a toggle switch and both pumps are brand new. I get around 8-10 mpg with this setup and I am...
  9. Noobie Bronco Tech Questions. Flame free zone!
    hey all! just joined fsb! i have an 86 f250 with the 44ttb and i have a 78 dana 44 here that i have cut all perch's and shock mounts off already and have my new perchs to weld on my question is has anyone done this? i dont have money for a 60 sas so thats out of the question i no a little bit...
1-9 of 9 Results
Top