Bronco Forum - Full Size Ford Bronco Forum banner
1996
1-9 of 9 Results
  1. Noobie Bronco Tech Questions. Flame free zone!
    My exhaust is cracked in multiple spots and a few brackets have actually broken so i have decided to look into getting it redone. I have been looking into new headers, so if anyone has opinions on long tube or shorty headers that would be appreciated. I really like the look of a dual exhaust so...
  2. Noobie Bronco Tech Questions. Flame free zone!
    I was scrolling through Facebook and saw a picture of a burnt up bronco and read that there was a recall at some point because of this. I figured I should buy an extinguisher just in case. What kind do some of y’all carry?
  3. Noobie Bronco Tech Questions. Flame free zone!
    Planning on putting the bassani Y pipe with no cats on my truck. I know I have to weld a bung on for the downstream O2 sensor but I was wondering if anyone had a link to a MIL eliminator or bypass of some sort for it? I can’t seem to find any and I just don’t want to get an engine code from it...
  4. Noobie Bronco Tech Questions. Flame free zone!
    So one day I was just driving down the road and my radio suddenly stopped working. Discovered that my fuse popped and I replaced it. As soon as I started my truck it popped again. I took my radio out to check all my connections were all in and I put another one in and it popped again. My dome...
  5. Noobie Bronco Tech Questions. Flame free zone!
    I am wanting to put a bigger cam in my 1996 bronco 5.8. Any recommendations on what cam i should put in? Besides the cam, is there anything else I should upgrade to insure that there will be no issues with it when it runs? Also should I get it tuned after I install it? Any feedback is really...
  6. 1980-'96 Bronco Tech
    Hi everyone, I've scoured the forums but I'm stuck chasing a ghost and hope you can help. 96 XLT keeps blowing fuses when I turn on the left turn signal or the flashers. Blowing both the #7 & #13 fuses. So far I've done all of the following and still can't seem to find the problem. Replaced...
  7. Mountain States Chapter
    Hey gang - new to the site and Bronco ownership! Anyone been to All American 4x4 off of Santa Fe? Just moved to Littleton and picked up a ‘96 with a fresh lift, needs alignment bad! That shop is right up the road.
  8. Noobie Bronco Tech Questions. Flame free zone!
    Hey guys I have a 95 MAF 302 that just all around taking a dump, I found a 96 302 with low miles. My plan is to keep the 95 ecm and wiring harness. I was considering swapping it in and from what I can tell the only differences are the manifolds and the y pipe which I would reuse from my 95 so...
1-9 of 9 Results
Top