Bronco Forum - Full Size Ford Bronco Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-10 of 10 Results
  1. Noobie Bronco Tech Questions. Flame free zone!
    Long time lurker, first time poster. I’ve got a 1988 Bronco, 5.0 v8. The thing was POURING coolant and it looked like it was the water pump, so I went ahead and replaced it, all new seals and silicone. Poured new coolant in and it poured out the same way, even with the engine off. I can’t seem...
  2. Noobie Bronco Tech Questions. Flame free zone!
    I’ve got a leak coming from the trans cooler line housing(?) at the radiator where the trans cooler line goes into the rad (see photos). It’s definitely coolant, not ATF as you can prob tell from the pics. It appears to have been coming from behind (rad side of) that rusty washer looking part of...
  3. Noobie Bronco Tech Questions. Flame free zone!
    1996 bronco with 351w. Anyone know where to source a new setup similar to shown in the picture with a clear coolant leak? Or is there a better aftermarket solution? Or does anyone know what the threads are so I can get some generic plumbing fittings?
  4. 1980-'96 Bronco Tech
    I was driving home one night from work and as I was easing off the throttle I noticed a drip coming from under the dash in the passenger foot-well. Pulled over, shut everything off and looked and saw that the floor mat was wet with what looked like coolant. Kind of oily with somewhat of a...
  5. 1980-'96 Bronco Tech
    Please watch the video and provide me with your ideas!!!!! Radiator has been replaced as well as all hoses, thermostat, water pump. All felpro gaskets with rtv… what the hell is going on?! *************UPDATE The upper left corner of the timing cover to block gasket is leaking
  6. 1980-'96 Bronco Tech
    I had a leak today and found a lose bolt on the Passenger side, right above the starter. Does anyone know what this part is?
  7. Noobie Bronco Tech Questions. Flame free zone!
    Hello everybody, Dumb question here I pulled a stupid. I was attempting to swap out my engine block heater cord, and I felt a bent bolt somewhere right next to where the cord T’s in. I pulled the bolt a little bit and coolant started draining out. Now I can’t find where the bolt is actually...
  8. Noobie Bronco Tech Questions. Flame free zone!
    So I’ve bought a 92’ XLT bronco 351w at about 191xxx miles a few months ago. I’ve done all regular maintenances aswell as entire new distributor, driveshafts, U joints, TPS, IAC valve, tranny filter and new fluid,B&M tranny pan. Had the transmission worked on as far as transfer case housing was...
  9. Noobie Bronco Tech Questions. Flame free zone!
    Well.. another leak I have to fix before I can get this damn thing on the road 🤬. I was hoping to be able to drive it around for a bit to check the performance of the 5.0 and AOD. My buddy who I got the Bronco from said it was leaking oil and coolant. He definitely wasn't lying. So I found the...
  10. Noobie Bronco Tech Questions. Flame free zone!
    Can anyone give me some help identifying the source? Only starts when its up to temp and thermostat opens, i attached a video to show the speed of the drip as well as the pain of being dripped on..... drip video
1-10 of 10 Results
Top