Bronco Forum - Full Size Ford Bronco Forum banner
dana 44
1-5 of 5 Results
  1. Noobie Bronco Tech Questions. Flame free zone!
    Hello all, young lad here just getting into trucks, looking to do a SAS on my 1990 ford F150 4x4. I currently have acquired a rolling frame with the drivetrain aswell. The frame I'm told is a 1977 Ford F250, i belive it has a dana 44HD low pinion, leaf spring, up front and a dana 60 in the rear...
  2. Noobie Bronco Tech Questions. Flame free zone!
    So I was getting ready to put my Right Shaft (passenger side)back in to the stub shaft (the one that has the dust boot on it). Well the manual said it could only go on one way. The pub says: " Since the splines on the shaft are phased, there is only one way to assemble the right shaft and joint...
  3. Noobie Bronco Tech Questions. Flame free zone!
    I replacing the seals in my DANA 44 Front Axle. I am trying to make sure I have all the seals. The tech manual exploded view is a good reference but I am not seeing all the part numbers. (1) DANA 40773 Front Right Inner (Is this passenger side where the shaft goes into the housing?) (1) DANA...
  4. Noobie Bronco Tech Questions. Flame free zone!
    I am replacing my U-joints in the front axle (DANA 44). I am reading the tech manual on how to break it down and put it back together. I have youtubed some videos on how to pull the shafts. I keep finding ones only for the Left side, not the Right side that include pulling the Stub shaft. I am...
  5. Noobie Bronco Tech Questions. Flame free zone!
    I am going to replace the front U-Joints on my axle. They are 30 years old so its probably time. I have seen a few videos that mention to be careful with the size you get because they maybe a little big for the steering knuckle and you have to grind the ends a bit. I found DANA 5760X, should...
1-5 of 5 Results
Top