Bronco Forum - Full Size Ford Bronco Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-18 of 19 Results
  1. 1980-'96 Bronco Tech
    I have a 1987 bronco witch the break lights not work. They rarely turn on very very briefly when the breaks are pressed down. I’m sure it’s a wiring thing. Looking at the pedal I find 2 things I have no clue about. Any information to these 2 items would be great. otherwise, If there is any...
  2. 1980-'96 Bronco Tech
    I'm renovating a stock '86 FSB. My windshield drain was full of soil & clogged and the filling of the trap resulted in a long line of rust along the bottom of the trap. To repair, I'm pulling the dash so I can access that area easier to clean & fiberglass the bottom of the trap and replace the...
  3. Noobie Bronco Tech Questions. Flame free zone!
    I've decided to rewire the entire electrical system in my bronco due to years of others jerry rigging everything (wish me luck!). As I've pulled things off, I've been buying new parts while I have things taken apart seeing what could use replacing. I've attached a picture of a vacuum valve...
  4. Noobie Bronco Tech Questions. Flame free zone!
    So I have a 1991 Ford bronco 5.0 302 I recently took my battery out to charge it and replace the terminals. After a long day I ended up putting the battery in backwards. After replacing alternator, fusible links, ign. module, fuel pump, starter solenoid, batt terminals, and computer yet to no...
  5. Noobie Bronco Tech Questions. Flame free zone!
    Guys and gals... I'm in big trouble. I have a 1987 with the 4.9 straight six and a 4 speed Tremec 4 speed manual transmission. I bought this truck a couple years ago and have had electrical issues since day one. I bought it as a project truck and was able to do a bunch of work on it myself, but...
  6. Noobie Bronco Tech Questions. Flame free zone!
    I recently replaced my starter solenoid and now my truck has no power at the key. Not even accessory lights. I turn the key and nothing happens. I can still connect the terminals on both solenoids and it will crank. I really wanted to run around with the top off on the 4th of July too, and all...
  7. Noobie Bronco Tech Questions. Flame free zone!
    So every time I pull the headlight switch, fuse #10 blows. I used a multimeter and it seems to be a short to ground. Instead of blowing through all my fuses, I just plugged a 12v light into the fuse socket. If the light is on, there's a short. I've been looking through wiring diagrams for weeks...
  8. Noobie Bronco Tech Questions. Flame free zone!
    I have a 1988 5.8L V8 351 windsor small block with some deep electrical issues. I'm looking for a new fabricated injector harness and an ECU harness. No one in the world seems to have any of this and I do not want to part out connectors and build my own. Does any company make these? Any advice...
  9. Noobie Bronco Tech Questions. Flame free zone!
    I was wondering what I need to know about changing interior wiring harness on my 96 XL. Does it need to be same year and model? Could I take a F150 XL wiring harness and it work? Any tips on switching? What else I should know about changing wiring harness? Thanks
  10. Noobie Bronco Tech Questions. Flame free zone!
    Hey guys! im still abit new on finding the small tips and tricks for the bronco, but i need some help, i noticed that the lights in the cab/main and all around when the truck is on they pulsate on a high rate, i got my friends dad to check and he said its a ground. Well maybe its the alternator...
  11. 1980-'96 Bronco Tech
    Bought an 84 I just got back from major repair and my turn signals worked for one drive after I bought it. The #5 (15A) fuse was blown and worked once it was replaced for the drive. Now all exterior turn signals wont work and no indicators on the inside. Brake lights and emergency flashers work...
  12. Noobie Bronco Tech Questions. Flame free zone!
    I'm trying to repair the wire from the magnetic clutch in my bw1356 electric shift transfer case. The wire is broke and missing the pin that goes into the connector off the transfer case shift motor. The picture below is of the pins from the speed sensor that goes in the same connector. Anyone...
  13. Noobie Bronco Tech Questions. Flame free zone!
    Tachometer does this while cold, and acts floppy/laggy when warm. Rev the car and the tach responds but not accurate whatsoever Yall think its a short, bad gauge, or something else? also yes I know I need a new bulb
  14. Noobie Bronco Tech Questions. Flame free zone!
    PLEASE HELP!! So I had to change the lights in my cluster. they all worked at one point, but out of nowhere my RPM meter stopped working and my speedometer jumps like crazy and registers backwards, and the 4x4, low range, antilock, and all the other lights on the bottom dont work. Battery...
  15. Noobie Bronco Tech Questions. Flame free zone!
    Hi all. So a little backstory. I was cleaning up some wiring under my dash and without noticing I knocked my ammeter gauge, and it was touching the metal bracket. I go to fire the truck up later that evening and under the hood starts smoking. I shut it off and run to pull the negative cable and...
  16. 1980-'96 Bronco Tech
    My 1983 is giving me a hard time with electrical things. My latest is the high beams keep blowing out. I put in new headlights, and as soon as i hit the high beams, the high beam bulbs blow. The low beams are working fine still. I couldn't find any blown fuses either. What is going on??
  17. 1980-'96 Bronco Tech
    I have a 92 Bronco with a 5.8 . It started acting up like it was running out of gas then would clear up and run then repeat later. I finally parked it and it wont fire at all now. I have changed everything I can think of electrical and fuel wise. Including fuel pump, filter. & regulator. The...
  18. Noobie Bronco Tech Questions. Flame free zone!
    I have a 1981 Bronco, with a 302. It was originally an inline 6, it looked like someone dropped a 'junkyard' engine in it. The wiring all looks decent, but I can't keep fuse #12 from blowing. The truck won't start without it. I tried several new starter solenoids, and got the truck to start...
1-18 of 19 Results
Top