Bronco Forum - Full Size Ford Bronco Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-11 of 11 Results
  1. Noobie Bronco Tech Questions. Flame free zone!
    I have a bad Drive Gear and need to replace it (Previous owner lost Speedo and replaced cable, sensor and driven gear, but not drive gear... I'm thinking a bound cable killed the drive gear and he didn't get the chance to replace it because spinning the driven gear by hand makes the speedo...
  2. 1980-'96 Bronco Tech
    Okay so I have gone through the forums and searched for my issue and the fixes of fuses and the cluster itself did not fix. I have a 1990 Bronco that I bought with Speedo, Fuel Gauge and Oil Pressure Gauges not working. Previous owner said they all went out at once. I have goes through my fuses...
  3. Noobie Bronco Tech Questions. Flame free zone!
    Hi everyone! I have a 90 full size xlt with the 5.0L and AOD. My instrument cluster/gauges are intermittently inaccurate. I know that they're never actually very accurate or a good indication of oil pressure, etc.; but I want them to work normally. I hate manual gauges zip tied under the dash...
  4. 1980-'96 Bronco Tech
    How To Remove Gauge Cluster & LED UPGRADE Ford Bronco OBS F150 F250 F350
  5. Noobie Bronco Tech Questions. Flame free zone!
    I've been trying to figure out why my thermostat gauge and fuel gauge hasn't been working right. I took the gauge cluster out and found that the laminated circuit board has a couple places that are burned out. Also it seems that the little square resistor board isn't allowing any voltage...
  6. Noobie Bronco Tech Questions. Flame free zone!
    Hello again, so Ive been thinking about changing over to led instrument cluster lights, nav lights and the 4x4 and low range lights, I already have some led lights like the dome lights and the door panel lights, and at one point i had put some in the nav lights but then they didn't work so i put...
  7. Noobie Bronco Tech Questions. Flame free zone!
    So some people have said that a problem im having might be the cluster and it could be since when it goes from 40-45 it jumps around like crazy, also the coolant needle isnt in its place and the oil one is the same. Is there any tutorials on how to fix this? or is there a good shop i can...
  8. Noobie Bronco Tech Questions. Flame free zone!
    Tachometer does this while cold, and acts floppy/laggy when warm. Rev the car and the tach responds but not accurate whatsoever Yall think its a short, bad gauge, or something else? also yes I know I need a new bulb
  9. 1980-'96 Bronco Tech
    So I'm still new here and am figuring everything out. I have a '95 XLT and my temp gauge reads cold no matter how long I drive. I have replaced the thermostat and it is in the correct direction and I also replaced the temperature sender. The top radiator hose does get hot so I know that I'm...
  10. 1980-'96 Bronco Tech
    1995 XLT 5.0L I have already replaced the temperature sender and the thermostat and my temperature gauge stills reads cold. The gauge itself works properly because when I ground the wire it reads hot and when open it reads cold. However, when I have the engine warmed up, the top rad hose is...
  11. Noobie Bronco Tech Questions. Flame free zone!
    PLEASE HELP!! So I had to change the lights in my cluster. they all worked at one point, but out of nowhere my RPM meter stopped working and my speedometer jumps like crazy and registers backwards, and the 4x4, low range, antilock, and all the other lights on the bottom dont work. Battery...
1-11 of 11 Results
Top