Bronco Forum - Full Size Ford Bronco Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. 1980-'96 Bronco Tech
    Howdy folks! So I just did a big job last month on my '96 Bronc' with the 351W. Water pump, timing cover, timing chain, harmonic balancer. Put quite a few miles on the thing since the repair and found no leaks (praise the lord, right?). Well just a couple days ago I noticed the dang thing is...
  2. Noobie Bronco Tech Questions. Flame free zone!
    I've had the pan in my garage forever and just needed to get this done so I had a shop install my new deep trans pan. Seemed fine, got home and noticed a small leak at one of the bolts. He said it was torqued to spec but to bring it back and they can tighten it a little more. The tech was...
  3. Noobie Bronco Tech Questions. Flame free zone!
    So i was working on my truck recently and just cleaning it up, i could smell a hint of gas constantly from the driver side where there's gas cap is, but its not going away, is there some kind of vent or line that i should look into ? also problem when filling up, kind of sprays back at me ...
  4. Noobie Bronco Tech Questions. Flame free zone!
    Hey guys. I like others on her damaged my Transmission Cooler Lines replacing my radiator on my 94 Bronco 5.8L. I shopped around and found the best deal was at inline tube and before asking here went ahead and ordered. 1993 Ford Bronco 2wd & 4wd EOD 5/16" Trans Cooler Lines 2pc, Stainless 1...
  5. Noobie Bronco Tech Questions. Flame free zone!
    I lifted up my rubber mats today and noticed a pretty large area of the carpet on the drivers side was moist. I had gotten a car was a day or two prior, but the discoloration and smell of the carpet leads me to believe it's been sitting wet for some time now. It wasn't drenched/pooling with...
  6. 1980-'96 Bronco Tech
    Showin you my 85: 351w, c6, etc & etc.with some problems. check out the pics: dirty as a mofo I'm hearing some knocking from this neck of the woods. This is looking north towards the port side of the tranny. Isn't there supposed to be some bolts here? Wasps' nest on my starter: thought...
  7. 1980-'96 Bronco Tech
    I am sure this has been covered before but I Don't have a clue to where to start looking in the forums for my problem. My Truck is very sluggish and shaky at low rpm and a low gear or uphill. It has new plugs, wires, cap and rotor, and coil. New tranny and transfer case. I have checked for...
1-7 of 7 Results
Top