Bronco Forum - Full Size Ford Bronco Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. 1980-'96 Bronco Tech
    Has anyone else had issues with MAF swap running lean to the point of pinging at startup, and for 1-3 minutes after? I'm guessing it's because the calibration is at the MAF sensor, been meaning to get into rt tuner to bump up the fuel map in open loop. I don't think it's an issue with my setup...
  2. 1980-'96 Bronco Tech
    90 XLT, 351w E4OD. So I just finished installing a MAF kit from fiveology racing, along with 36lb injectors on an otherwise stock engine (heads/cam to come). Starts up just fine, but it only runs for about 5-10 seconds before slowly dying. If I blip the thottle, it bogs and dies. If I slowly...
  3. General Discussion/ Bronco and Wheeling related.
    Hello Everyone, I have a 1994 Bronco with a bad 5.0L/E40D/auto transfer case and I am rebuilding a 5.8L Speed Density/E40D/manual transfer case from a 1994 F-150 in order to swap the 5.8L into the Bronco. I would like to retain the MAF wiring harness from the 5.0L and swap in the 5.8L. I am of...
  4. Noobie Bronco Tech Questions. Flame free zone!
    First, sorry for another thread about MAF conversion. I have been looking through the forum for a week or so now and am still a little confused about what I am doing wrong here and hope that someone can spell it out for me. I recently purchased a 1989 bko that the previous owner had attempted to...
  5. 1980-'96 Bronco Tech
    I am going to be ordering a 408 for my 89 bronco. I want to keep efi. Planning on doing a MAF swap. So here is where my question starts could you run a air gap manifold and fabricate a elbow of sorts and mount your throttle body to it? My reason is I have a air gap laying around and I know the...
1-5 of 5 Results
Top