Bronco Forum - Full Size Ford Bronco Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. 1980-'96 Bronco Tech
    Hello all. I had an issue with my 86' Bronco hesitating when driving at slow city speeds and giving it very little throttle. It felt like the engine was not getting sufficient fuel. Based on reading the forum this sounded like a potential fuel pressure regulator issue. The part is cheap, so I...
  2. Noobie Bronco Tech Questions. Flame free zone!
    Well after I've replaced all the different sensors like the MAP, TPS, IAC, etc...new plugs, plug wires, coil, cap and rotor...things seemed to be going pretty good... Then it got HOT outside. I can run around most of the morning with no issues...then afternoon temps in the mid to upper...
  3. Noobie Bronco Tech Questions. Flame free zone!
    Hey guys. I’ve been working on this bronco from the ground up. Learning a ton. I’ve not been able to figure out why my truck sounds like it’s having a misfire. It runs rough and shakes after it warms up. No smoke in exhaust. Just smells like it’s running rich. VIDEO Currently my cat is off...
  4. Noobie Bronco Tech Questions. Flame free zone!
    So I've been searching around on the forums for a little while now and haven't found an answer to my problem so here we go. Just bought the rig a week ago and it didn't have a fuel tank or in tank fuel pump. The old one had basically rusted together and was trashed. I replaced that and got the...
  5. Noobie Bronco Tech Questions. Flame free zone!
    First, sorry for another thread about MAF conversion. I have been looking through the forum for a week or so now and am still a little confused about what I am doing wrong here and hope that someone can spell it out for me. I recently purchased a 1989 bko that the previous owner had attempted to...
  6. 1980-'96 Bronco Tech
    This is going to be a little long winded so bear with me, but I wanted to provide as much info as I could. :) So don't know if anyone remembers me, but back in maybe 2008-2009 I had a stroker/maf project on here. Long story short I never got it running right and lost motivation and the truck...
  7. 1980-'96 Bronco Tech
    Ok. Where to begin on this one... Alright, I've owned my 94 bronco XLT for about 3 years now with 133,000 miles on it. In the last 2 months I've been having many problems. I recently had the slave cylinder replaced after it was bleeding out and froze the pedal to the floor. After that...
1-7 of 7 Results
Top