Bronco Forum - Full Size Ford Bronco Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-9 of 9 Results
  1. Noobie Bronco Tech Questions. Flame free zone!
    Can someone with more experience than me confirm my assumption on this video that the box is bad and not the rag joint please? Before I go replacing the box. Have play in the steering wheel.
  2. Noobie Bronco Tech Questions. Flame free zone!
    Hey everybody, I need some help. About a year ago I did a motor swap in my 1992 Bronco. During the motor swap I went ahead and replaced the old steering gear with a new one. At the same time, I replaced all the steering arms and tie rod ends. I removed all the old steering arms and laid them on...
  3. Noobie Bronco Tech Questions. Flame free zone!
    Replaced pitman arm and installed a reman steering box. Bronco steers like new, however the steering wheel is now off 30-45 degrees to the left. I believe I can lock left and the right same distance on the steering wheel. My wheels seem very straight and get no pull at all while driving. The...
  4. Noobie Bronco Tech Questions. Flame free zone!
    1995 bronco xlt, I got the nut loose (it was also seized but nothing a breaker bar couldn't handle) and confirmed the nut is moving freely without spinning the adjustment screw (its a flathead top). Can't get the screw to tighten or loosen at all. would wd40 or pb blaster help here? Not sure if...
  5. 1978-'79 Bronco Tech
    Hi guys -finally found my Type F for the steering pump and gear- Complete EMPTY system with new Gear and pump - Now lets fill it up and bleed it. Poured fluid in until filled to the neck and started to crank slowly lock to lock -did it a couple times and then checked pump-- Its still there and...
  6. Noobie Bronco Tech Questions. Flame free zone!
    I was testing to see if the ball joints are good in Bronco and this is what I found. The upper and lower ball joints seem good it, when I pushed and puled the top and bottom of the tire it didn't have a lot of play and seemed tight. When I pushed and pulled the sides of the tire, O boy did it...
  7. Blog
    I recently had the opportunity to stop by Red-Head Steering Gears in Seattle and meet with owner Harvey Foster. I found Harvey to be a very friendly person that was extremely knowledgeable and experienced with steering gears of all types. He was surprisingly more than willing to spend time...
  8. 1980-'96 Bronco Tech
    i have an 89 bronco eddie bauer ed. 4x4 fullsize with the 302. the frame on the side where the steering box has rusted out so the steering box is moving freely and going inside the frame and broke the bolts because of the slack , i was wondering if i can i get a machine shop to fab me up a plate...
  9. Noobie Bronco Tech Questions. Flame free zone!
    i have an 89 bronco fullsize with the 302. the frame on the side where the steering box has rusted out so the steering box is moving freely and going inside the frame and broke the bolts because of the slack , i was wondering if i can i get a machine shop to fab me up a plate with the holes...
1-9 of 9 Results
Top