Bronco Forum - Full Size Ford Bronco Forum banner

transfer case

  1. Noobie Bronco Tech Questions. Flame free zone!
    Ok so i was checking out how am i going to be able to change (for the moment) from normal to 4wd until i can either find or fix a transfer case motor, its more of a pet project then anything, i wanted to know a few things before i get into full on designing 1. how hard is it to manually shift...
  2. 1980-'96 Bronco Tech
    so the other day i was going about 50 on the highway and my bonehead friend thought it was a good idea to go ahead and push my 4x4 button and i immediately clicked it off but then my transfer case made some nasty whining noise and went away, now today theres a bit of humming at higher speeds...
  3. Noobie Bronco Tech Questions. Flame free zone!
    So im still new to some parts for these trucks, and i wanted to know if theres a whole kit i can put to change it to a manual transfer case? because i Barely do any off roading but if i do i dont want to 100% trust electrical motor that might burn up or short out, maybe thats why the previous...
  4. 1980-'96 Bronco Tech
    So while im saving up money to get everything up to date i went down to check on the wiring of the solenoid pack, while looking i decided to check the transfer, never go off road so i never really paid attention, well...... It looks like the previous owner just threw away the previous...
  5. Noobie Bronco Tech Questions. Flame free zone!
    I'm trying to repair the wire from the magnetic clutch in my bw1356 electric shift transfer case. The wire is broke and missing the pin that goes into the connector off the transfer case shift motor. The picture below is of the pins from the speed sensor that goes in the same connector. Anyone...
  6. Noobie Bronco Tech Questions. Flame free zone!
    I tried out my 4x4 the other day (new to me bronco), heard a loud popping sound coming from my transfer case. when I got home I pulled my transfer case and found the oil pump retainer bracket had worn through the case and got mangled in the gears (not good). I was able to find a kit online that...
  7. Noobie Bronco Tech Questions. Flame free zone!
    Hey, new to posting on the site, but you guys have helped me with a ton of other fixes. I have a 1996 XLT that will not shift into 4-Low. I have read another thread on here that discussed the same problem, but I've tried most, if not all of those solutions. I have it in neutral while trying to...
  8. Noobie Bronco Tech Questions. Flame free zone!
    Hello everyone, I've been trying to find a way to increase the ground clearance for my transfer case. I have a BW1356 with a stock skid plate currently. As it sits, (33" tires + 3" lift), the skid plate subtracts about 8+ inches from the bottom of the frame and i either get high centered or...
  9. Noobie Bronco Tech Questions. Flame free zone!
    I cleaned up the underside of my Bronco look for leaks. I found one on my transfer case, its looks like its right at the rear bearing retainer and rear cover. Besides taking off the yoke and seal how do I get the bushing out? Can I re-use the seal and bushing and do they make a gasket. Did...
  10. 1980-'96 Bronco Tech
    I bought a '90 fullsize with a 5.0, e4od, cruise control, BW1356 electric T-case and 35 inch tires. I brought it home on a trailor because the T-case was bad. I swapped in a good NP208. I'm not sure what year the NP208 came out of, if it was a M/T or A/T or if it ha s cruise control. The VSS...
Top