Bronco Forum - Full Size Ford Bronco Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. Noobie Bronco Tech Questions. Flame free zone!
    I've searched up and down this fine forum and cannot find a good answer on what size vacuum lines to buy. I intend to replace all of the lines, and have found the various diagrams, but for the life of me cannot find what size lines I need. I've seen ~3 or so answers all that differ wildly...
  2. 1980-'96 Bronco Tech
    Hi Team, I'm replacing the vacuum lines on my 93 with the 5.8/351w motor.... I think I got most of them run except for the top port on the TAB solenoid. I can't for the life of me figure out where this one goes (red arrow). I believe it has something to do with the smog but looking at some of...
  3. 1980-'96 Bronco Tech
    I need some help finding one of these vacuum fittings! I am in the middle of rebuilding the top half of my 1989 5.8L Bronco. I removed all fittings from the upper intake and the fitting below (?) what badly damaged and I want to replace it. The picture below is just a screenshot, not the actual...
  4. Noobie Bronco Tech Questions. Flame free zone!
    Hey all, I have an 86 Bronco and I've finally gotten around to fighting the electrical system; the dash is fully removed and now I'm putting wiring back together. The previous owner did some Frankenstein wiring, and my intent is to restore the truck back to original status with the addition of a...
  5. Noobie Bronco Tech Questions. Flame free zone!
    Hello everyone, I’m getting a loud vacuum leak type of noise on my 1993 5.8 that goes away when I give the truck throttle. I’m not sure if it’s actually a vacuum leak, just sounds a lot like one. I can’t find any leaks anywhere, anyone got any ideas?
  6. Noobie Bronco Tech Questions. Flame free zone!
    This is between the battery and the firewall on my ‘94 Bronco EB 5.8L What is this hose in red? Should it be hose clamped, it keeps coming off under power? What is the small canister in blue? There is nothing on the other side of the small canister (green), looks like another hose would fit...
  7. 1980-'96 Bronco Tech
    I need some help. I am having an issue with my 1996 Ford Bronco. It starts fine, idles fine, runs fine.......until it gets warm. Then it stalls when coming to a stop. Only when coming to a stop. It cranks right back up then shuts off at the next stop sign. I can sometimes catch it and throw it...
  8. Noobie Bronco Tech Questions. Flame free zone!
    ok so its a 1989 5.0 302 rebuilt engine. it was rebuilt by me due to a stupid mistake on my part after i bought it i never checked the intake and it was missing part of it and the fan shot water into the airbox and into the engine thus hydrolocking it ok so heres my problem it wont start...
1-8 of 8 Results
Top