Bronco Forum - Full Size Ford Bronco Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,240 Posts
Discussion Starter #1
We are doing a 460 swap from a 1979 Bronco that originally had a 351C in it. The Bronco has a 12" lift and we would really like to find pair of shorty headers for under $400. Does anybody have any suggestions other than getting stock manifolds from a 460 in the junkyard?
Thanks-
 

·
Ford Tatted On My Chest
Joined
·
1,456 Posts
what year of 460? I got a fuelie i put in mine and i just used some headers for the truck it came out of. i dont think they make shorties for these that i found, but mine are mid lengths and end bout the oil pan gasket area, and they had there own y pipe as well, all 3" stuff. worked good.
 

·
Registered
Joined
·
1,240 Posts
Discussion Starter #3
The engine is a 72-76, we believe. It was remanufactured. We are looking for fender well exit headers to run the exhaust on the outside of the frame rail to exit under the driverside door. Any suggestions other than expensive l&ls?
 
1 - 4 of 4 Posts
Top