Bronco Forum - Full Size Ford Bronco Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
604 Posts
Discussion Starter #1
out of a 68 chevelle ss

power pack heads
been professionly checked for cracks, cleaned, glass beaded, an painted
Stock internals
Balanced crank

350$ obo



Sb Chevy Edelbrock Torker manifold 40$


late 60's 70's chevy rochester monojet single barrel carb
rebuilt an flow benched for a hi po straight six



1964 4dr chevy2 ran an inspected up until 91 but still runs all original....bodies rough, only major rust holes are over the head light bezels besides that paint very worn an surface rust

interior is practically mint, dash an trim is suberb

3speed manual or "3 on the tree"
straight 6
professionly rebuilt rochestor 1bl carb
professionaly hot tanked, recoated, an sealed gas tank an sending unit

300$ obo




1964 ford falcon 80% finished little interior things needed now to complete

later carbed 302 from mustang
newly rebuilt an flow benched 2 bl carb
c6 tranny
8.8
dual exhaust
dash is all there an original interior *seats carpet etc.* is from a neon
QQ plates

3000$



PM or call 908 278 2778
 

·
Registered
Joined
·
604 Posts
Discussion Starter #3
Cobra Jet said:
any more pics of that Falcon? (interior, engine bay, more exterior - etc)

any rust or rot through? any major repairs needed?

this is a resto, the body has been gone thru all ready. your best bet is if you can get to plainfield you can hear it run an ill even let you open her up on the highway youll be surprised im letting this go so cheap

now that i have the digital camera ill get better pictures for you.... all i have are polariods an a broken scanner.
 
1 - 4 of 4 Posts
Top