Bronco Forum - Full Size Ford Bronco Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
hello, i have a 1978 ford bronco. When put in 4 wheel drive high or low the front end will not engage? Does anybody know what the problem might be? It was working fine about a month ago?
 

·
Registered
Joined
·
980 Posts
what did you check? to see if they were turned to the locked position or did you take them apart and see if they are working,
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #5 ·
checked if they are in looked position. just found out tonight that four wheel drive is not working. havnt had time to take it a part.
 

·
Premium Member
Joined
·
12,536 Posts
Get under it and with the T-case in 4wd try to turn the front driveshaft. If it turns freely it is the T-case. If it don't jack the front axle off the ground and get under it and try to turn the driveshaft. If the driveshaft turns and the wheels don't it is the ring and pinion or the lock outs. Start with a process of elimination 1st.
 
1 - 8 of 8 Posts
Top