Bronco Forum - Full Size Ford Bronco Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,615 Posts
Discussion Starter · #1 ·
i have a 76 dana 44 low pinion from a 3/4 ton that i was going to put under my 92. as i started to take it apart i found it had bad u joints and axle bearings. the calipers were frozen to the rotors so i didnt notice these problems when i bought it.i was going to put it under my 92 just to get it to move around the shop(i have it at work) but after seeing the condition i dedcided to bite the bullet and spend some money. i bought a dana 1990 60 kingpin yesterday from a yard at going rate and thourghly looked it over., so this dana 44 is taking up space and i am planning on scrapping it.
i have a dana 44 high pinion, what parts are interchangeable from the 3/4 ton d44 to the 1/2 d44? i noticed that the 3/4 d44 yoke looks to be the same as the d60. i plan on using the 1/2 44 on my 94 daily driver some time in future.
 

·
aka: kemicalburns
Joined
·
7,957 Posts
i would think everything except the ring/pinnion.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top