Bronco Forum - Full Size Ford Bronco Forum banner
1 - 2 of 2 Posts

·
MidlifeCrisisUndrWay
Joined
·
2,241 Posts
Discussion Starter · #1 ·
Does said fuel tank use same sending unit/fuel pump/EMS hole as my '94 Bronco's sending unit/fuel pump?

Not counting mounting the fuel tank and filler neck location; is it a simple swap/plug and play-functionally?

Said front fuel tank:
Rectangle Watercraft Automotive exterior Font Auto part






'94 Bronco fuel tank kit:
Gas Gadget Auto part Machine Metal
 

·
MidlifeCrisisUndrWay
Joined
·
2,241 Posts
Discussion Starter · #4 ·
The FPM is unlikely to sit deep enough in the tank to reach the bottom. I have a FPM from a 94 F-150 and it is several inches shorter than the 33 gallon Bronco version. I would have had to put the pump on some extension to make it work. Also the angle of the sender was such that my extension would have had to have a bend in it to locate the pump in the tank well. The stock FPM is already a snug fit in the 3 5/8" hole so I was doubtful an extension was going to make fitment any easier. The fuel level sender had the same challenges too.
Yes the hole is the same. But as noted above, the whole assembly is built for each specific tank: depth and angle and whatnot.
Good points.

Can I simply use the sending unit/fuel pump/vent port from the front fuel tank, then?
 
  • Like
Reactions: BigBlue 94
1 - 2 of 2 Posts
Top