Bronco Forum - Full Size Ford Bronco Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
90 Posts
Discussion Starter #1
Ok so I need some advice on where I can find a head for my 4.9l 300? I need it to be a complete setup. Should I buy new or reman?

I'm doing this on a budget, but I want it done right, so any advice on where to find one would be great!

Thanks,

Cody
 

·
Roller rockers are gay
Joined
·
19,191 Posts
junkyard? it's so rare that ANYTHING fails on these engines, i wouldn't think twice about getting a complete junkyard head. have it checked and decked at a machine shop, just to make sure it's all good and drop it on.
 

·
4:20 Enthusiast!
Joined
·
3,277 Posts
I took a head off a jy engine and havent a prob with it yet.That was at least ten years ago.
These 300's are dam near bullet proof.They have a lot of torque and run forever but you have to get used to the 0-60mph in ten minutes issues, there are fixes for that though. ;)
 

·
Registered
Joined
·
634 Posts
I took a head off a jy engine and havent a prob with it yet.That was at least ten years ago.
These 300's are dam near bullet proof.They have a lot of torque and run forever but you have to get used to the 0-60mph in ten minutes issues, there are fixes for that though. ;)
HEY! for your information they can do a 0-60 in 9 1/2 minutes! :goodfinge
 
1 - 6 of 6 Posts
Top