Joined
·
16 Posts
Does anyone know where I could locate the part number for a 1995 Bronco 5.0 part number for ABS anti lock brake module?
Anti-lock brake computer module
1 - 3 of 3 Posts
Joined
·
2,253 Posts
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
Still leaking oil after rear main seal replacement
Noobie Bronco Tech Questions. Flame free zone!Hi all, I’ve got an ‘88 bronco 351, c6 trans. So I just buttoned everything up after replacing my rear main and lo and behold the truck still leaks oil, and it only leaks when the truck is running. It’s leaking at about the same rate as before. I did notice the the oil pan gasket was a little...- 3
- 84
-
Remove Transfer case fill plug. BW 1356
Noobie Bronco Tech Questions. Flame free zone!Guys I need some help. I stripped the transfer case fill plug. Made the common mistake of using the square ratchet instead of a 10mm hex. I bought a 10mm hex to see if maybe I could extract it but no joy. Since then I've tried channel locks (nope), hammer and chisel (nope), hammer and...- 16
- 300
-
Siggy89 · updated
-
Pinion Angle
Noobie Bronco Tech Questions. Flame free zone!Needing some help on what pinion angle shims I need. The driveshaft is at 18 degrees and the yoke is at 9 degrees.- 9
- 281
-
Bayou1972 · updated
-
302 Cam And Rocker Selection
Noobie Bronco Tech Questions. Flame free zone!Seeing I'm not wanting a quarter mile monster or some swamp mudder. Seeing the engine swap is out, I've seem to have found three cams that I might need some help with. Looking for direction and if I'm going the wrong route tell me I'm wrong. You might of guess, ya I'm new to building trucks...- 15
- 271
-
TorqueO · updated
-
anyone use 16" or 17" wheels?
Noobie Bronco Tech Questions. Flame free zone!I'm about to lift my 96 Bronco 2.5/3" to use 33's. The stock wheels are 15x7.5 and many say the 12.5 width will work, others say the tire wears unevenly and the vehicle can wander. Before I look at 15x8 wheels, I thought I'd see if I should consider 16 or 17's. Vehicle is mainly street driven...- 4
- 170
Join now to ask and comment!