Bronco Forum - Full Size Ford Bronco Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
11,042 Posts
His is one way to do it... Summit IIRC sells the cheap kits, which is basically just a lawnmower control, the cable, and the mount.
 

· Registered
Joined
·
11,042 Posts
Makes sense to me. If you only had cable, when you operated the gas pedal, then your hand throttle would move, too. This way, the chain falls slack when the throttle pedal is used...
Definitely need it. 95% of the time, the cheesy cable operated hand throttles aren't completely smooth and bind just a little, especially if they get used a lot.

The chain link resolves that problem.

And uh, I think I'd skip the fishing line. :duh
 

· Registered
Joined
·
11,042 Posts
Yeah, I was joking about the fishing line. ;)

I'd skip using it anyway though. The ball-chain would have an easier ability to drop and sag when you press on the throttle. Wire steel would be more likely to bind, or bend and kink, considering the short distance you'd have it set up as.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top