Bronco Forum - Full Size Ford Bronco Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
I think I know the answer to this but ya never know. I ran a string line from bottom of the brake drum to the same point on the other brake drum of the rear end as an offset because the rearend looks bent but both drivers side and passenger side of the pumpkin are the basically 4 1/2" up from the string on both sides of the pumpkin and 5" out next to the drums. so 1/2" on each side. Is there any way that its supposed to be out a 1/2" or is just bent the same on both sides?............Thanks,Roy
 

· Registered
Joined
·
11 Posts
Discussion Starter · #13 ·
Yeah, I know about the sensor but a 9" can be modified to accept it or there is a shop in Brea that will machine your yolk to accept the sensor behind the transfer case instead from what I have read........Thanks, Roy (love the desert)
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top