Bronco Forum - Full Size Ford Bronco Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
788 Posts
I've always just PB'd the crap out of them and used a 6-point 1/4" drive socket to break them loose. Unfortunately if you've already rounded it off I'd just go the vice grip route, and replace it with a new one.

If that fails I'd just replace the whole wheel cylinder as someone suggested earlier.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top