Bronco Forum - Full Size Ford Bronco Forum banner

1 - 11 of 11 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter #1
Hey, I've been on the forum for a while, just haven't made many post. I have a 1983 351W/ C6. When I purchased the Bronc it was UGLY and needed a tranny. The previous owner had installed 33 m/ts, a reman engine with edelbrock intake and carb.

Here is what I've done so far:

New Paint
Lots of interior work
Power window motors
Wieand Water pump
Flex Fan
Complete tune up w/ frpp wires
Rebuilt tranny and added shift kit
rebuilt T case
High torque starter
New Dual exhaust
New U-Joints
Holley 670 cfm Truck Avenger Carb
Electric Fuel pump, dual feed line, regulator
Warn Hubs
and a bunch of little stuff

Here is what I have purchased and working on:
1978 Ford truck, donor
SAS 44 front 4.56 / Spool
9" rear 31 spline 4.56/ spool
15/38.5/15 Gumbo monster mudders
9500 lb winch/ cradle combo
roof basket
rock sliders
CB
Lights
Shorty Headers
Custom Bumpers / recievers for winch

I have a ways to go. But I have all these parts in my possesion. I hope to have the axles swapped in a couple of weeks. I can't wait to go break something.

Anyone from GA gonna let me wheel with them when I'm finished?
 

·
Registered
Joined
·
27 Posts
sounds like it's gonna be a killer beast...what part of GA?
 

·
Registered
Joined
·
30 Posts
Discussion Starter #6
I'm in northeast GA. The city I live in is Talmo, but no one has heard of that, so I will say between Athens and Gainesville.
 

·
Registered
Joined
·
30 Posts
Discussion Starter #8
I have some current pics. I will definetly be doing a before and after. I spend to many hours at work, not enough Bko time if you know what I mean. I'm not sure how to post the current pics.
 
1 - 11 of 11 Posts
Top