Bronco Forum - Full Size Ford Bronco Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
74 Posts
Discussion Starter #3
He doesn't know what motor the truck was running. Maybe if I was a better Ford guy I could identify the bell housing. But the trans is ready to run. He has it on ebay to get maximum exposure but if you email him a offer he is more then willing to entertain it.:thumbup
 

·
Registered
Joined
·
74 Posts
Discussion Starter #5
RTM said:
More than likely it was behind a 351M/400 motor but it will fit a 460 as well.
I always get screwed up on that one. I keep thinking that the 351 uses a small block bolt pattern.
 
1 - 6 of 6 Posts
Top