Bronco Forum - Full Size Ford Bronco Forum banner
1 - 20 of 22 Posts

·
Registered
Joined
·
256 Posts
Discussion Starter · #1 ·
cleaning out garage make offer

for sale and we have a list
big block c6 trans 4x4 out of 79 f150 $125 or best offer
[url=http://www.supermotors.net/vehicles/registry/media/669271][/URL][url=http://www.supermotors.net/vehicles/registry/media/669272][/URL]
big block e4od and bw 1358 tcase out of 90 f350 has 105,000 miles on it $300or best offer
[url=http://www.supermotors.net/vehicles/registry/media/669275][/URL]
np 205 out of 79 f150 needs rebuild $150.00
[url=http://www.supermotors.net/vehicles/registry/media/669107][/URL][url=http://www.supermotors.net/vehicles/registry/media/669109][/URL]
np208 out of 85 bronco this t-case was rebuilt and used for on year$150 or best offer
dana 20 j series out of early bronco needs rebuild $100 or best offer
[url=http://www.supermotors.net/vehicles/registry/media/669111][/URL][url=http://www.supermotors.net/vehicles/registry/media/669113][/URL][url=http://www.supermotors.net/vehicles/registry/media/669277][/URL]
1990 ford 460 injected has 105,000 miles have under hood harness brackets hoses oil cooler starter and many more parts $300 or best offer
[url=http://www.supermotors.net/vehicles/registry/media/669260][/URL][url=http://www.supermotors.net/vehicles/registry/media/669264][/URL][url=http://www.supermotors.net/vehicles/registry/media/669265][/URL][url=http://www.supermotors.net/vehicles/registry/media/669266][/URL]
these are chevy flat tops that I was going to use on my ford dana 44 hvae knuckles spindles and brake backing plates best offer
[url=http://www.supermotors.net/vehicles/registry/media/669115][/URL][url=http://www.supermotors.net/vehicles/registry/media/669117][/URL][url=http://www.supermotors.net/vehicles/registry/media/669119][/URL]
dick cepek light bar sold
bronco tail gate 1987thru 199? sold
pm me every thing most go
all parts are pick up only
 

·
Registered
Joined
·
835 Posts
PM sent on lightbar.
 

·
Behold my
Joined
·
1,275 Posts
Be honest with me here. I've been keeping an eye out for a build motor and here's one. Would it be reasonable to do? 105 isn't too much, but would it just be easier to buy a block and work from there? Also, where are you in Mitchigan?
 

·
Registered
Joined
·
256 Posts
Discussion Starter · #12 ·
well this motor was running when I pulled it out and have most of the stuff to get it running agian . I was thinking wow 460 and the more I thought about it it just was not worth my time or money to build (have 400 hp 351 win) in corner so I am going back to it you caan buy the block and start from there but then you have to buy crank rods pistons , if you are going to you will need heads and intake I have herd thank the ones on this block are restricktive, but that is your call. I am north of detroit south of romeo
 
1 - 20 of 22 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top