Bronco Forum - Full Size Ford Bronco Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
153 Posts
Discussion Starter · #1 ·
...I asked this question in the middle of a different thread... but it probably deserves its own post...

after collecting parts (at a slow pace, due to a small wallet)... I am at the point that I need to buy springs then I will be able to actually LIFT my bronco. Im pretty well set on using the Deaver (superflex?) 6 inch rear springs (with NO blocks).

-- for the front. I want to know, pros n cons... variable rate or constant rate coils? (cage or deaver 6 inch front coils)...

what are your opinions and exerience(s) with either one?

thanks

Shane

PS current parts collected for lift. Sterling 10.25, Dana 60 (1979), Cage radius arms. assorted cage small parts (pitman arm, radius arm mounts, D60 axle mouts, trac bar mount... etc)...
 

·
Registered
Joined
·
153 Posts
Discussion Starter · #6 ·
I guess I should have mentioned that this rig is being build for primarily trails, mud etc (not necessarily rocks) but may be driven on the street (as a toy, not as a daily driver.. I have a... ahem 97 escort for that)...

Shane
 

·
Registered
Joined
·
153 Posts
Discussion Starter · #7 ·
well after waiting for a while to see if cage would get their 6 inch springs back in stock, and talking with them (they say it may be a long time before they re-order them). I purchased the 6 inch deaver coils, along with the 6 inch deaver leaf springs for the rear. Getting closer... just with my darn wallet would fill up faster!

Shane
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top