Bronco Forum - Full Size Ford Bronco Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
485 Posts
Discussion Starter #1
I just put new u-joints in my drive shaft, greased the slip joint. I bought a new cv head and I can't get the last u-joint cap on. I have the u joint installed in the cv head, and the nuckle is installed on the remainder of the drive shaft. Is there a trick to doing this.I just can't get enough clearance to get the last cap on.
 

·
Kitteh Commandaar!
Joined
·
4,191 Posts
Are you refering to the Cardan joint in the back? I believe there is a rightup on how to change/rebuild the rear driveshaft.
 
1 - 2 of 2 Posts
Top