Bronco Forum - Full Size Ford Bronco Forum banner

1 - 6 of 6 Posts

·
That SmackMyB$tchUp Guy
Joined
·
1,011 Posts
Discussion Starter #1
When pulling the shafts out of the housing is there supposed to be any dif fluid leakage? When I pulled the drivers side (short) shaft, I got some fluid leaking out.

does this mean the seals are bad?

BTW - seals are new...1 year and less that 10K miles.
 

·
That SmackMyB$tchUp Guy
Joined
·
1,011 Posts
Discussion Starter #3
Not at an angle. Could be over full, I'll check that out. I had new seals installed by the shop when they did my gears and spools so maybe they messed it up?

The shaft was dry when I pulled it and it started to very slowly run out when I pulled the shaft out.
 

·
That SmackMyB$tchUp Guy
Joined
·
1,011 Posts
Discussion Starter #5
Yep, thats it. Thanks Zach.
 
1 - 6 of 6 Posts
Top