Bronco Forum - Full Size Ford Bronco Forum banner

1 - 5 of 5 Posts

·
aka: kemicalburns
Joined
·
7,824 Posts
Discussion Starter #1
hey guys, need to know if this can be done by me or do i need to send it in someplace.

thanks
 

·
OUT OF BUSINESS / M.I.A.
Joined
·
10,874 Posts
it really needs to be pressed off and back on, and there is a diaganal pin in the shaft. If you have to ask I'm guessing you shouldn't do it alone :shrug
 

·
aka: kemicalburns
Joined
·
7,824 Posts
Discussion Starter #3
thats fine, i just called a local auto electric shop and they said it could be around 80+ to have it done because they have to ship it out and such. this really sucks, i had no idea they stopped using the tfi module on the 351 after 91
 

·
Registered
Joined
·
787 Posts
i just called a local auto electric shop and they said it could be around 80+ to have it done because they have to ship it out and such
Just punch out the pin with a drift, and drive the gear off.
Press on the new gear, and install the pin.

$80 for that??

Go to a local shop.. give the guy $10 and ask to use his press, and 10 minutes later you'll be done.
:beer
 

·
aka: kemicalburns
Joined
·
7,824 Posts
Discussion Starter #5
well i just called a shop, he said its not hard at all. he would do it for $40. I might give it a try first

late
 
1 - 5 of 5 Posts
Top