[buckshot362]

I just put a 6" lift on my bronco and now i'm needing to lengthen my d-shaft's. My question is how much longer did you guys have to make your driveshafts to work properly? If my measurements are right it should be somewhere around 37.5" frome u-joint to u-joint on the rear, does this sound correct? Thanks for any help.

 

[78moneypit]

Your joking right git a tape measure and measure it yoke to yoke.:twak

 

[BrokeCuzWheelin]

Measure the distance between the flat part of the yokes (center of the u-joint cap). Make sure the yokes are in the same orientation to each other and the vehicle is on flat ground at ride height. That is how most d-shaft shops want it measured.