Bronco Forum - Full Size Ford Bronco Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
553 Posts
Discussion Starter · #1 ·
84 Bronco with Heddman hedders (long tube). I was laying out the route for my dual exhaust. When i did a temp bolt up of the collectors off the headders I noticed that I will either have to go under my tranny x-member (pipe will be hanging down under the frame-real ugly) or go over the x-member. Just wondering how other members dual's are...
 

·
Registered
Joined
·
553 Posts
Discussion Starter · #4 ·
it's a 84 bronco. But it's a all custom build. I'm using a NP200 t case. The OEM exhaust manifolds and pipe went above the tranny x-memeber if I remember correctly. I just installed my heddmans and the collectors are almost dead center of the tranny x-member with about a 3" gap between the two. I'm leaning towards going under because the bend will be real steep to go above.
 
1 - 2 of 2 Posts
Top