Bronco Forum - Full Size Ford Bronco Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
Ok so here is my problem. I have a 93 Speed Density 5.0 bronco which i recently built a new engine for the setup is as follows
Mustang 5.0 .030
windsor jr. cast heads
B303
harland sharp rockers 1.6
Edelbrock truck efi
BBK TB twin 56mm
BBK adj FPR
now heres my problem the guy i want to bring it to for the tuning says that with speed density all he can do is fuel and spark curves for $400+ but the engine is barely running right now is there any other options i can do maybe swapping to mass air? like later bronco ecu for a 5.0 w/ e40d and mass air? i also have a mustang ecu with the maf sensor but the tuner guy said that i would need a stand alone comp for the e40d from baumannengineering to run it.

Any help will be greatly appreciated
Thanx in advance
 

·
Registered
Joined
·
11,108 Posts
ummmmmmm??????????
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top