Bronco Forum - Full Size Ford Bronco Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hey guys new to the page and looking for a little advise. I recently purchased a 1993 Bronco. Engine ran decent but was gutless and had a lot of blow by so I have since pulled the motor and will be taking it to machine shop for a rebuild. Shop says that they are 6-8 weeks out soo while I wait I am researching rebuild ideas. I am not looking for a 500 hp monster. Stock horsepower listed as 200 hp 300 ft lb tourqe. Would like to get around 100 hp increase out of this rebuild. Seller says the trans was very recently rebuilt so I’m going to run with it for now. Planning on doing a full emissions delete (found some very helpful posts concerning the subject here on the site) and swapping out stock exhaust manifolds for long tube headers. Considering the need for swapping out the heads to achieve my 100 hp increase goal but this is a little beyond my skill level.
Any advise would be appreciated.

Thanks,
 
1 - 1 of 1 Posts
Top