Bronco Forum - Full Size Ford Bronco Forum banner
Status
Not open for further replies.
1 - 7 of 7 Posts
G

·
Discussion Starter · #1 ·
I bought this a few months back and have no use for it. I had it built to match my measurements flange to flange at ride height installed is 29.25"

The shaft is new and measures 27.5 collapsed and 31.5 extended as shown in the pics.





Fedex ground says $30.00 bucks from my zip 03042 to Scottsdale AZ, so i would imagine shipping to be 45 or less countrywide.

I would like to get $150.00 + shipping.

This is for my 94' with E4OD bw 1356 and 8.8, and again it is all brand new. I found my current shaft is fine, i had other issues so now i have this one just sitting on a shelf.

I prefer paypal

Im also selling off some extra d44 radius arms and axle shafts. Will take pics and post those shortly.
 

·
aka: kemicalburns
Joined
·
7,916 Posts
bump for a good price
 

·
Registered
Joined
·
61 Posts
did you ever sell this driveshaft? If not I will be in phoenix area in next two weeks. Let me know if you still have. Thanks
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top