Bronco Forum - Full Size Ford Bronco Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Alright folks...heres the deal im trying to buy a 78 bronco...heres what the guy told me...but i have no idea where to start...i wanna do it all myself if at all possible since i am mechanically inclined but ive done mostly engine work up till this point...

1978 Full size Bronco, 351m engine, np205 transfer, ford 9in rear diff, dana 44 front diff. New front Grill, tow bar, driver and passenger floor pans, lightbar with 4 kc lights. upgraded front and rear drive shafts from 1/2ton to 3/4ton all new u-joints and yokes. front drive shaft needs to be extended 2 inches. 4 in rough country lift kit with dual shock on front, 37x13.5x15 Iroc super swampers with less than 200 miles on them.
 

·
Mud God - R.I.P.
Joined
·
5,788 Posts
Take it to your local drive line shop.
If the shafts in good shape retubing isn't that bad $
 

·
Registered
Joined
·
2,900 Posts
yeah just measure it from yoke to yoke and have a drive shaft shop extend it. I've had my shaft shortend or lengthened a few times and its not too expensive.
 
1 - 3 of 3 Posts
Top