[GKR]

Sorry if it's considered a double post but I figured this would be a good place for the question. Just installed Autofab rear bedsides. I haven't put any hardware along the area under the window. Fender feels very secure without it. Any concerns with this from those who have run these fenders? Thanks.

 

[PBR]

mine has 1 button along the bottom of the window for support, but i don't know if it's necessary.

 

[flyinbronco]

Mine use two buttons below the window just like John's Bronco in the link below.
http://www.autofab.com/Bronco.htm

I'm pretty sure it will be OK but it may let a lot of mud and stuff fling out through the gap thats sure to open when the body twists a bit.

I'm looking forward to meeting you and checking out your Bronco at the Oregon Dunes trip.

 

[GKR]

Thanks for the reply guys.:beer
I'm thinking a little flex might be good in my case......trees and all.
I want to make an inner fender liner like the one in the pic of the streched white Bronco that was posted here awhile ago.

Lookin forward to meeting ya'll too. It will probably seal my fate in getting a second Bronco and building a Pre-runner:whiteflag