Bronco Forum - Full Size Ford Bronco Forum banner
1 - 1 of 1 Posts

·
Cadillac of Men
Joined
·
3,787 Posts
i think fireguy's method would be the easiest and almost as good as welding in a new piece. if you put large (enough to cover the open seam by at least 1/2") washers on either side of the floor, and then a new bolt thru, it will spread out the stress from the seats much better than just the bolt. You could primer the seam so that it doesnt start rusting. This should stop further damage, and in the future if you have the chance, have it a new floorpan welded in.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top